Difference between revisions of "Category:Smart IoT Sensor"
(This page includes documentation, examples and resources to use the Smart IoT Sensor.) |
(No difference)
|
Revision as of 15:46, 13 December 2016
[Category:Products]
Welcome on the wiki page of the Smart IoT Sensor!
This page includes documentation, examples and resources to use the Smart IoT Sensor.
Contents
1 What is the Smart IoT Sensor?
The Smart IOT sensor is dedicated to prototyping IoT applications using wireless technologies such as SIGFOXTM, LoRaTM, BluetoothTM Low Energy, GPS/GNSS.
In order to offer the fastest development time for application’s proof of concept, this product is 100% compatible with the Arduino IDE.
The board is made out of an host Atmel ARM Cortex M0+ MCU directly driving on-market, industry certified modules to enable connectivity. Sensors such as BMP280 (temperature/pressure) and ADXL-345 (accelerometer) are directly available on the board to meet user's application, as well as GPIO, including SPI and I2C to cover the widest range of peripherals.
2 Key features
- Arduino IDE Compatible
- LoRaTM / SIGFOXTM/ FSK
- Bluetooth Smart (4.2)
- GPS / GLONASS / Galileo
- USB Interface
- Embedded battery charger
- All antennas included
- User programmable RGB LED
- Sensors:
- Accelerometer
- Temperature + Pressure
- Free GPIOs
- Dimensions: 50mm*50mm*25mm
3 General information and getting started
Smart IoT Sensor Getting Started
Smart IoT Sensor Hardware Reference
4 Peripherals and Application Examples
4.1 Modules
LoRa/Sigfox module:MM002 en NEMEUS website Sigfox?
- Modulation : LoRaTM / SIGFOXTM/ FSK
- Maximum output power +14 dBm
- Power efficient
- Good buildings penetration
- Long Range protocol stack software
Bluetooth Smart (Low Energy) chipset: nRF51822 on Nordic Semi website
- Bluetooth 4.1 Compliant (Bluetooth Smart)
- Software upgradable to Bluetooth 4.2
- TX power: up to +4 dBm
- RX sensitivity: down to -93 dBm
GPS/GNSS module: SIM33ELA on SIMCom website
- Accuracy: 2.5m standing
- Time-To-First-Fix:
- Cold starts: 28 s (typical)
- Warm starts: 26s
- Hot starts: <1s
- EPO Assist: 13s(CTTFF)
4.2 Sensors
Temperature/Pressure: BMP280 on Bosh website
Accelorometer: ADXL345 on Analog Devices website
4.3 GPIO
Several GPIO are available on the scratchpad:
- Arduino's analog pins A3, A4 and A5
- Arduino's digital pins 7, 8, 9 and 13
- Communication bus as SPI and I2C
4.4 Use cases
Pages in category "Smart IoT Sensor"
The following 2 pages are in this category, out of 2 total.
