Difference between revisions of "NIS-MB Modbus Modem"
From nemeuswiki
(Created page with "Category:Sensors [[File:|thumb|400px|Modbus Modem]] = General information = {{:NIS Overview}} = Mechanics = * Dimensions 60 x 95 x 85mm (109mm including fixing brackets)...") |
(→Wiring) |
||
| Line 44: | Line 44: | ||
|- | |- | ||
|} | |} | ||
| + | |||
| + | JP1 and JP2 are NC. | ||
By software configuration, three possible modes are available: UART CMOS level, RS232 and RS485 bus. | By software configuration, three possible modes are available: UART CMOS level, RS232 and RS485 bus. | ||
Connect your power supply to the terminal block as shown in the picture. | Connect your power supply to the terminal block as shown in the picture. | ||
Latest revision as of 17:36, 6 March 2018
[[File:|thumb|400px|Modbus Modem]]
Contents
1 General information
1.1 Overview
- LoRa™ WAN 1.0.2 EU Class A & C
- Activation by Personalization (ABP)
- Over-The-Air Activation (OTAA)
- SIGFOX™ ready
- Fully certified on major LoraWan & Sigfox networks
- Easy to use and deploy
- 3.6V / 2200mAh Primary battery Li-SOCl2 embedded
- Magnetic switch and LED to ease the installation
- RoHS conform / Pre-Certified ETSI EN 300-220 / RED compliance under certification
1.1.1 RF Performance
- TX Power 14 dBm (25 mW)
- RX Sensitivity -137 dBm
- Approx. 10 km range
- Integrated PCB antenna
1.1.2 Environment
- Operating temperature -40°C to +85°C
- Storage temperature 30°C recommended (to limit battery self-discharge)
- Rel. humidity 0% to 95% (not condensing)
1.1.3 Options
- External antenna
- SDK for your SW development purposes
- 10-30V external power supply
- Compatible with the NEMEUS PicoGateway for private networks
1.2 Installation
By using the internal antenna, the position of the sensor is critical.
Install your product as high as possible, and prefer unobstructed area (concrete and metal are the worst materials).
If you cannot fulfill these conditions, it is still possible to use an optional external antenna.
2 Mechanics
- Dimensions 60 x 95 x 85mm (109mm including fixing brackets)
- 96mm spacing between brackets
- IP 65
- Solid ABS & PC material
3 Features
- three modes: UART CMOS level, RS232 and RS485 bus.
- Modbus slave device.
- allows to connect a PLC to sigfox or LoRaWAN network.
4 Wiring
| Target connection |
| 1 : GND |
| 2 : GND |
| 3 : CMOS_UART_TX |
| 4 : CMOS_UART_RX |
| 5 : A_RS485 |
| 6 : B_RS485 |
| 7 : RX_RS232 |
| 8 : TX_RS232 |
JP1 and JP2 are NC.
By software configuration, three possible modes are available: UART CMOS level, RS232 and RS485 bus.
Connect your power supply to the terminal block as shown in the picture.
