MM002-L-EU SW Versions: Difference between revisions
Jump to navigation
Jump to search
MM002-LS-EU SW version (list of implementations and corrections) |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[Category:MM002]] | |||
[[Category:Modules]] | |||
== master16W18
== | |||
=== master16W18_08
=== | |||
Implementations/Improvment
s | |||
* improve boot time | |||
* modify/remove some traces | |||
* sliding duty cycle implemented | |||
* RF: | |||
** add preamble length to RFRX parameters | |||
** use RFRX fixed_len parameter to set the Rx payload length | |||
* LoRaWAN | |||
** set backoff according to adr when backoff AT parameter is absent | |||
** process new channel request before Link ADR request to apply new datarate with new channels | |||
** detect channel mask error in LADRRequest only when all enabled channels are not compatible (Objenious requirement) | |||
** add management of downlink channel for RxW1 (V1.0.2) | |||
** ensure that dr-backoff or datarate modification doesn't mute the device | |||
** make retransmission backoff procedure independent of ADR bit | |||
=== master16W18_07
=== | |||
Implementations/Improvment
s | |||
* stop command parsing when unknown command is detected | |||
* decode aggregated duty-cycle from 4 LSbits of the command | |||
=== master16W18_06
=== | === master16W18_06
=== | ||
Latest revision as of 16:24, 24 October 2017
master16W18
master16W18_08
Implementations/Improvment s
- improve boot time
- modify/remove some traces
- sliding duty cycle implemented
- RF:
- add preamble length to RFRX parameters
- use RFRX fixed_len parameter to set the Rx payload length
- LoRaWAN
- set backoff according to adr when backoff AT parameter is absent
- process new channel request before Link ADR request to apply new datarate with new channels
- detect channel mask error in LADRRequest only when all enabled channels are not compatible (Objenious requirement)
- add management of downlink channel for RxW1 (V1.0.2)
- ensure that dr-backoff or datarate modification doesn't mute the device
- make retransmission backoff procedure independent of ADR bit
master16W18_07
Implementations/Improvment s
- stop command parsing when unknown command is detected
- decode aggregated duty-cycle from 4 LSbits of the command
master16W18_06
Implementations/Improvment s
- Radio offset is configurable via AT+RF=RPER/SPER commands
- Add battery level parameter in AT+MAC=RVAR/SVAR
- Add AT+RFRX=RCS command to read RSSI when RF is in continuous RX mode
master16W18_05
Corrections
- downlink message is class A type when received in Rxw1 or Rxw2 (Rxw2 case was not detected)
master16W18_04
Corrections
- Fix persistent RXTimingSetupAns response type
master16W18_03
Corrections
- Unsollicited +MAC:RDEVADDR was not always sent
master16W18_02
Corrections
- Deprecated AT command could impact next AT command
- First downlink frame with FCnt=0 has invalid MIC
- Downlink frame is pushed 2 times on UART when FPending bit is set and piggyback is enabled
- APPSKEY and NSKEY are uncorrectly read on boot when MAC is OFF
- Ciphering might be disabled for port 0
master16W18_01
Qualifications
- Orange
- Objenious(Bouygues)
- Actility